Routing IP routing
AnywhereUSB® Plus User Guide
519
iii. For Domain, type the domain name.
iv. Repeat to add additional domains.
n
Default route: Matches packets destined for the default route, excluding routes for
local networks.
13. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a new routing policy:
(config)> add network route policy end
(config network route policy 0)>
New route policies are enabled by default. To disable:
(config network route policy 0)> enable false
(config network route policy 0)>
4. (Optional) Set the label that will be used to identify this route policy:
(config network route policy 0)> label "New route policy"
(config network route policy 0)>
5. Set the interface on the AnywhereUSB Plus device that will be used with this route policy:
a. Use the ? to determine available interfaces:
(config network route policy 0)> interface ?
Interface: The network interface used to reach the destination.
Packets that satisfy the matching criteria will be routed through this
interface. If the interface has a gateway then it will be used as the
next hop.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
To Next Page
Loading...
Need help?
General