Digi AnywhereUSB Plus User Manual

Routing IP routing
AnywhereUSB® Plus User Guide
520
Current value:
(config network route policy 0)> interface
b. Set the interface. For example:
(config network route policy 0)> interface /network/interface/eth1
(config network route policy 0)>
6. (Optional) Enable exclusive to configure the policy to drop packets that match the policy when
the gateway interface is disconnected, rather than forwarded through other interfaces:
(config network route policy 0)> exclusive true
(config network route policy 0)>
7. Select the IP version:
(config network route policy 0)> ip_version value
(config network route policy 0)>
where value is one of any, ipv4, or ipv6.
8. Set the protocol:
(config network route policy 0)> protocol value
(config network route policy 0)>
where value is one of:
n
any: All protocols are matched.
n
tcp: Source and destination ports are matched:
a. Set the source port:
(config network route policy 0)> src_port value
(config network route policy 0)>
where value is the port number, or the keyword any to match any port as the
source port.
b. Set the destination port:
(config network route policy 0)> dst_port value
(config network route policy 0)>
where value is the port number, or the keyword any to match any port as the
destination port.
n
upd: Source and destination ports are matched:
a. Set the source port:
(config network route policy 0)> src_port value
(config network route policy 0)>
where value is the port number, or the keyword any to match any port as the
source port.

Digi AnywhereUSB Plus Specifications

General

Brand	Digi
Model	AnywhereUSB Plus
Category	Switch
Language	English