Virtual Private Networks (VPN) OpenVPN
AnywhereUSB® Plus User Guide
632
6. To configure the device to reboot when the interface is considered to have failed:
(config vpn openvpn client openvpn_client1)> connection_monitor reboot
enable
(config vpn openvpn client openvpn_client1)>
7. Set the Interval between connectivity tests:
(config vpn openvpn client openvpn_client1)> connection_monitor interval
value
(config vpn openvpn client openvpn_client1)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
(config vpn openvpn client openvpn_client1)> connection_monitor interval
600s
(config vpn openvpn client openvpn_client1)>
The default is 15 minutes.
8. Determine whether the interface should fail over based on the failure of one of the test targets,
or all of the test targets:
(config vpn openvpn client openvpn_client1)> connection_monitor success_
condition value
(config vpn openvpn client openvpn_client1)>
Where value is either one or all.
9. Set the number of probe attempts before the WAN is considered to have failed:
(config vpn openvpn client openvpn_client1)> connection_monitor attempts
num
(config vpn openvpn client openvpn_client1)>
The default is 3.
10. Set the amount of time that the device should wait for a response to a probe attempt before
considering it to have failed:
(config vpn openvpn client openvpn_client1)> connection_monitor timeout
value
(config vpn openvpn client openvpn_client1)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set timeout to ten minutes, enter either 10m or 600s:
(config vpn openvpn client openvpn_client1)> connection_monitor interval
600s
(config vpn openvpn client openvpn_client1)>
The default is 15 seconds.
To Next Page
Loading...
Need help?
General