Digi AnywhereUSB Plus

Command line interface Configuration mode
AnywhereUSB® Plus User Guide
693
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, create a new user with the username user1:
n
Method one: Create a user at the root of the config prompt:
(config)> add auth user user1
(config auth user user1)>
n
Method two: Create a user by moving through the configuration:
a. At the config prompt, enter auth to move to the auth node:
(config)> auth
(config auth)>
b. Enter user to move to the user node:
(config auth)> user
(config auth user)>
c. Create a new user with the username user1:
(config auth user)> add user1
(config auth user user1)>
4. Configure a password for the user:
(config auth user user1)> password pwd1
(config auth user user1)>
5. List available authentication groups:
(config auth user user1)> show .. .. group
admin
acl
admin
enable true
nagios
enable false
openvpn
enable false
no tunnels
portal
enable false
no portals
serial
enable false
no ports
shell