Digi SM-300 - Specification Setting; Customer Specification (Re-zero 141)

SM-300 Service Manual
18
KEY TO PRESS OPERATION
Clear SRAM data and files initialize.
CHANGE SPAN SWITCH
3.2.1.2 Default Country Specification 2
Default Customer Specification (Re-zero 141) setting of individual country only.
(Please off the scale, press the following key and on the scale when process the following)
KEY TO PRESS OPERATION
+
Select country SPEC then default Customer Specification
setting.
C-SPEC, ENT (C) & (*)
COUNTRY CODE: 2-STD
KEY TO PRESS OPERATION
Refer to the
Section
3.2.1.3 for
country list
Reading SPEC for the standard country.
SELECT LABEL LENGTH
ENTER: 0 SHORT