SM-300 Service Manual
39
4.2.3 Peel Sensor
The peel sensor.
To set the peel sensor voltage if the peel sensor is not
working normally in some situations like temperature
and humidity changed.
The peel sensor voltage can be set automatically by
press the # key.
KEY TO PRESS OPERATION
At R mode.
0.000 0.00 0.00
0.000
KEY TO PRESS OPERATION
+
PEEL SENSOR VOLT: 4.9V
NEW: 0.0V / * AUTO SET
KEY TO PRESS OPERATION
Once the key is press, it will auto set the voltage value and
exit to R mode.
OR
Enter a value of the
sensor voltage then
press
You can enter the value of the peel sensor voltage then
press the PLU key to save and exit to R mode.
OR
Exit to R mode without doing anything.
0.000 0.00 0.00
0.000
To Next Page
Loading...
Need help?
General
