Digi SM-300 - All Server Configuration

SM-300 Service Manual
64
KEY TO PRESS OPERATION
Save the address and escape to Z mode.
OR
Escape to Z mode without saving.
TO CLEAR DAILY TRANS
PRESS PRINT KEY
Z
REMARK: Please restart the scale every time after changing the SPEC.
IMPORTANT: Please take note that each scale must have different port number and Ethernet address as the
other. Same port number and Ethernet address would make the network to a standstill. These apply to other
equipment sharing the same hub or link up. To avoid complication in the network, try to have the scale network
with it own PC Ethernet card and hubs (a suggestion only).
6.2.2.3 Server IP Address
KEY TO PRESS OPERATION
Go to Z mode.
TO CLEAR DAILY TRANS
PRESS PRINT KEY
Z
KEY TO PRESS OPERATION
+
Display default Server IP address.
SERVER IP ADDRESS
192168000000