Digi SM-300 - Maintenance Procedures; Diagnostic Functions; Changing Operating Mode

SM-300 Service Manual
23
3.2.3 Specification Setting
3.2.3.1 Customer Specification (Re-zero 141)
To change the setting of the Customer SPEC if there is some SPEC need to alter.
KEY TO PRESS OPERATION
At R mode.
0.000 0.00 0.00
0.000
KEY TO PRESS OPERATION
+
At the Customer SPEC setting at SPEC 0.
SP0: IT BARCODE 04>>04:
F1F2CCCCCXXXXXCD
KEY TO PRESS OPERATION
To
OR
+
OR
Select data.
Save data and increase SPEC No.
SP1: R.S.DATA OF IT BAR
1>>1: PRICE