Digi SM-300 - Pole Display Disassembly

SM-300 Service Manual
48
KEY TO PRESS OPERATION
&
Press Preset key 7 & 8 to select the job.
Then
1. Spec. Data save to FL-1
2. Spec. Data read from FL-1
3. Verify files with FL-1
SPEC. DATA SAVE TO FL-1
KEY TO PRESS OPERATION
Transferring result status.
It will display after all data is transfer.
SPEC. DATA SAVE TO FL-1
KEY TO PRESS OPERATION
Back to Z mode.
TO CLEAR DAILY TRANS
PRESS PRINT KEY