Dobot M1 - Installing Air Pump

Dobot M1 User Guide 3 Hardware Installation
Issue V1.3.4 (2019-05-23) User Guide Copyright © Yuejiang Technology Co., Ltd
18
(Optional) Installing End Effector
You can install the matching gripper, suction cup, or laser on the end of the Dobot M1 for
transporting, intelligent sorting and laser engraving. Figure 3.2 shows the size of the end effector of
Dobot M1.
Figure 3.2 Size of the terminal
Installing Laser Engraving Kit
Figure 3.3 shows the laser kit.
Figure 3.3 Laser kit
Procedure