Dobot M1 - Page 8

Dobot M1 User Guide 1 Security Precautions
Issue V1.3.4 (2019-05-23) User Guide Copyright © Yuejiang Technology Co., Ltd
5
meanwhile the red indicator on the base of the robotic arm will be on and this is a normal
phenomenon. At that point, you need to click J3+ under the Joint coordinate system on
the M1Studio page to jog the robotic arm to the position where the J3 value is above
10mm, and then the alarm will be cleared.
 When powering on the robot arm for the first time, please ensure that the emergency stop
switch has been opened (The emergency stop button is released). Otherwise, the robotic
arm will not work normally. If the emergency stop switch is not opened, please rotate the
emergency stop button clockwise. The emergency stop button will be released when
rotating to 45°.
 Please DO NOT connect the power cable to the Dobot M1 directly without power
adapter. Otherwise, the machine will be damaged.