Doremi ShowVault - Introduction; Purpose; Presentation; Applicability

1 Introduction
1.1 Purpose
This manual is designed to guide the user through the set up and installation of the ShowVault.
1.2 Presentation
This document is structured according to the following sections:
• Section 1: Introduction - Overall presentation of the document
• Section 2: ShowVault Presentation - Overview of the ShowVault
• Section 3: Rear Panel Connectors - Overview of the connections on the ShowVault
• Section 4: ShowVault IP Address - How to set up the IP address on the ShowVault
• Section 5: Device Manager Set Up - How to set up and use the Device Manager utility
• Section 6: Automation Set Up: Macro Editor Usage
• Section 7: Time Zone Set Up - How to check and update the Time Zone
• Section 8: Control Panel - Overview of the utilities in the Control Panel
• Section 9: ShowVault Software and Firmware USB Upgrade Instructions
• Section 10: ShowVault Linux Commands - Basic Linux terminal commands
• Section 11: Troubleshooting
• Section 12: Appendex A: XML Structure
• Section 13: Annex A: Netmap Configuration File
• Section 14: Annex B: Device Manager Configuration
• Section 15: IMB Certainty Presentation
• Section 16: IMB Certainty and Barco Series 2 Projector Set Up
• Section 17: IMB Certainty and NEC Series 2 Projector Set Up
• Section 18: IMB Certainty and Christie Series 2 Projector Set Up
• Section 19: GPIO and Audio Pin-Out Schema
• Section 20: Acronyms
• Section 21: Document Revision History
1.3 Applicability
This document complies with software version 2.0.10 and with IMB Certainty Revision E. For
previous version of the software and earlier IMB Certainty revisions, see version 1.0 of this
document.
_____________________________________________________________________________________
SHV.OM.001293.DRM Page 11 Version 1.3
Doremi Cinema LLC Confidential