Doremi ShowVault - Performing the Software Upgrade; Sending the Firmware File to the Showvault

• When prompted for a user name type admin and then press "Enter"
• When prompted for a password type the "admin" password and then press "Enter"
• Type: bin and then press "Enter"
• Type: cd ./etc/rc.once and then press "Enter"
• Type: put dcp2000_patch-0.5.2-26.pkg and then press "Enter"
• When the transfer is completed type bye and then press "Enter"
Note: These steps may vary depending on the FTP client and whether user is on a Linux or
Windows PC. The login information, file names, and destination folder are the same in
both cases.
10.4.2 Performing the Software Upgrade
• To perform the upgrade of the ShowVault software simply reboot the unit
• Login as "root" and from the terminal command prompt type: reboot and then press
"Enter"
• Once the ShowVault has rebooted login again as "root"
• Open a new terminal command and type: halt and then press "Enter"
• This command will initiate the shutdown of the ShowVault unit
• After approximately 20 seconds or so, the unit will shut off automatically
• After the ShowVault has shutdown power it on and log in
• This will complete the software update
10.4.3 Sending the Firmware File to the ShowVault
• To send a new firmware file to the ShowVault JPEG-2000 decoder use a FTP client and
log in as follows:
• Type: ftp 192.168.100.50 and then press "Enter" (IP address of the ShowVault)
• When prompted for a user name type admin and then press "Enter"
• When prompted for a password type the "admin" password
• Type: bin and press "Enter"
• Type: cd ./etc/rc.once and then press "Enter"
• Type: put fw-1.53.pkg and then press "Enter" (fw-1.53.pkg is the upgrade file that is
received from Doremi)
_____________________________________________________________________________________
SHV.OM.001293.DRM Page 66 Version 1.3
Doremi Cinema LLC Confidential