• Enter the "DLP Head IP" address and then click the “test” button
Note: If user enables subtitles without the ShowVault being connected to a projector the server
will not operate properly.
• Specify if this is the primary projector or not using the corresponding radio button
Note: The "DLP Username and Password" are not used.
• Check the “Enabled” check box at the top right corner of the GUI
• Click the “Save” button to record these settings
• A password confirmation page will appear, enter the password to save and record the
settings
5.1.2 Removing a Projector
• To remove a projector click on its name on the left part of the "Device Manager" GUI
• Click the “Delete” button (see Figure 22 above)
5.2 Automation Libraries Management
Support for theater automation control is also provided. The list of currently supported devices is
the following:
• eCNA
• JNior
A pre-built library of supported automation commands is available for each of these two devices.
These automation commands can then be added to Macro Cues as presented in Section 6.2.
5.2.1 eCNA Device
5.2.1.1 eCNA Device Addition
• To use the eCNA device click the “Add” button and select “eCNA”
• Enter the eCNA device IP address in the appropriate field as presented below:
_____________________________________________________________________________________
SHV.OM.001293.DRM Page 26 Version 1.3
Doremi Cinema LLC Confidential
To Next Page
Loading...
