Servicing: 9040, 9040 IP65, 9040S
A36951-C.doc
113/236
Ŷ Prolonged shutdown
NOTE Any shutdown can be made into a series of short shutdowns,
regardless of length, provided that the printer is started and ran
a minimum of twice a week with the jets in a running or refresh
mode for at least one hour.
Printer out of service for eight to fifteen days
1. Flush the umbilical conduit and head.
Refer to the procedure for flushing the umbilical/head contained in this section.
Printer out of service for 15 days or longer.
The printer needs to be drained and flushed. This operation can either be performed
manually or automatically using the drain/flush unit available from Markem-Imaje.
ʄ Automatic Drain/Flush
Refer to the automatic printer Drain/Flush procedure contained in this section.
ʄ Manual Drain/Flush
This operation consists of five stages:
1. Drain the ink circuit
2. Flush the ink circuit
3. Drain the ink circuit
4. Flush the ink circuit
5. Flush the umbilical(s)/head(s).
Refer to the Drain ink circuit, Flush ink circuit and Flush umbilical/head procedures
contained in this section.
To Next Page
Loading...
