Servicing: 9040, 9040 IP65, 9040S
A36951-C.doc
115/236
Ŷ Servicing
Head cleaning
Tools required
Ƒ Servicing tray
Ƒ Screwdriver, cleaning flask and blower bulb (or drying kit)
NOTE Cleaning the head once a week is adviced to obtain optimal
printing performances.
1. Stop the jet(s)
/Status Jet(s)/JET SHUT
DOWN.
2. Position the head onto its
maintenance holster.
Open the head cover.
Close the gutter screw
located in the print head:
3. Clean the electrodes and the
cannon(s) with cleaning solution to
remove all dried ink.
To Next Page
Loading...
