Servicing: 9040 Contrast
A36951-C.doc
134/236
Ŷ Drain/flush printer
CAUTION Disconnect the printer from the main AC supply after each
drain/flush operation - unless ink is going to be introduced
immediately. This is to avoid having the stirrers rotating with no
fluids in the system.
Drain and rinse the printer before any work, which requires
disconnection from the main AC supply for more than two
hours.
1. Place a recovery container under the additive tank and remove the drain plug from the
additive drain tube.
2. Refit the additive drain plug when the tank is empty.
3. Pour flushing solution into the additive tank. Use one liter if you plan to take the
printer out of service for less than 15 days or two liters if the shutdown is expected
to be longer than fifteen days.
4. Place a recovery container under the ink tank and remove the ink tank drain plug from
the ink tank drain tube.
1
Ink tank drain tube
2
Additive tank drain tube
NOTE Never re-use this ink.
1
2
To Next Page
Loading...
