Daily operation
A36951-C.doc
55/236
This sub-menu shows the readings recorded in the printer, logged in real time plus all
faults detected by the printer.
Ƒ Status jet(s): Jet status. This field also provides access to maintenance functions.
See Maintenance section for further details.
Ƒ Speed jet 1 and Speed jet 2: jet speed expressed in meters per second (m/s).
Ƒ Phase jet 1 and Phase jet 2: drop control or phase detection (000011110). Three
or four consecutive ones (1) correspond to the ideal jet break-off point setting.
Ƒ Pressure: operating pressure, expressed in bars.
Ƒ Viscosity: viscosity of the ink, expressed in centipoises (cps) and seconds (s).
Ƒ Elect. Temp. : Temperature of the cabinet electronics compartment, in degrees
Celsius (°C).
Ƒ Ink Temperature: Ink circuit temperature (except for 9040 Contrast models)
Ƒ Motor Speed: motor speed, expressed in rpm (except for 9040 Contrast
models)
Ƒ Transfer: time to transfer ink from viscometer to accumulator, in seconds. (9040
Contrast only)
Ƒ Reference visco.: Reference viscosity value which machine uses as basis for
adding additive.
Ƒ Additions: number of times additive added by printer since last start-up.
ƑFAULTS: _ : The box is checked if one or more faults or alarm conditions are
detected by the printer. Press the spacebar when you are on this line to display the
list of problems detected. A recommended remedy is displayed for each fault.
View programming parameters
Printer preparation/Options/Versions
This function allows you to view the version of the programs contained in your printer,
together with the printer serial number. You can re-enter the printer serial number if it
becomes lost.
To Next Page
Loading...
