Dover Markem Imaje 9040 - Replacing the AC Supply Fuse

Maintenance
A36951-C.doc
156/236
Ŷ Replace AC supply fuse
Tools required:
Ƒ Allen key (2.5 mm).
Ƒ Screwdriver.
The system uses a 4A time delay fuse.
Figure 1
Fuse location
1. Shut down the printer and disconnect it from themain AC power supply.
3. Undo the four screws (1) with the Allen key and remove the cover.
2. Disconnect the power supply cord from the printer.
4. Remove the fuse-holder next to the power point with a screwdriver.
5. Replace the fuse.
6. Fit the fuse holder and the cover back in position.
7. Reconnect the power supply cord from the printer.
8. Connect the printer to the AC supply and start the printer.
1