Maintenance
A36951-C.doc
142/236
5. Open gutter screw.
6. Select and confirm: STABILITY
7. When the jet is stable in the gutter,
select and confirm JET SHUT DOWN.
8. Clean the print head thoroughly.
9. Select and confirm JET START UP to restart the jet(s).
Make a visual check to ensure jet(s)are in the gutter.
Close the head cover again and press
to clear fault
conditions.
NOTE In some cases, these three functions can be used individually
or may need to be repeated two or three times.
Before making adjustments
/Status jet(s)/JET ADJUSTMENT
This function starts up the jet(s) and overrides faults associated with the jet(s). This means
that fault conditions will not prevent you from making adjustments.
To Next Page
Loading...
