Maintenance
A36951-C.doc
162/236
Ŷ Change ink:
CAUTION Check consumable expiration dates shown on the container
labels.
Frequency: see the IRS – Ink Running Specifications or ink technical data sheet.
Perform following procedures when printer is in service:
1. Drain additive tank by removing the additive drain plug from the additive drain tube.
Refit the additive drain plug when draining is completed.
2. Place a recovery container beneath the ink tank. Remove the drain plug from the ink
tank drain tube.
3. Select and confirm theProduction/Maintenance/Drain function. The printer shuts
down when draining has been completed.
4. Refit the ink tank drain tube plug.
5. Pour ink into the tank (max. half full/1 liter).
6. Start the printer normally, check to ensure the print head is clean, clean if required.
7. Check the jet break-off point when the printer has been in operation for a minimum of
30 minutes. This setting may need to be adjusted after the ink has been changed.
1
Ink tank drain tube
2
Additive tank drain tube
1
2
To Next Page
Loading...
