Maintenance
A36951-C.doc
143/236
Align jets
Printer preparation/Initialization/Jet alignment
This function aligns output from the jet(s). Alignment consists of identifying the jet that is
the slowest and assigning corresponding delay settings to the other jets.
Select a Jet number and then enter a number of Alignment units or adjust alignment
using the + and - buttons.
Example: Two-jet head
Jet 1.2 is the slowest jet. Jet 1.1 therefore needs to be delayed by three units to bring it
into alignment with reference jet 1.2.
CAUTION Make sure you have established the direction of printing before
you identify the reference jet.
Jet 1.2
Jet 1.1
Printing direction
Reference
Offset of one trame
To Next Page
Loading...
