Installation and configuration
A36951-C.doc
191/236
Configure message library
Production/Message/Library
This function is used to make a preliminary selection of messages from a general list of
messages in memory in the PC board.
The selected messages can be shown to the user in the form of customized lists, which
can be specific to each head if required.
CAUTION The number of messages in the library must always be greater
than the number of heads on the printer.
The library can contain a maximum of 127 messages.
ʄ Create a library
Select the messages and enter them into the library.
Ƒ Go to the general list and highlight the message concerned using the arrow keys,
Ƒ Press
,
The message is shown in the list of messages in the library. Messages are sorted in
increasing numerical order.
If you have a two-head printer, messages are assigned alternately to head 1 and then
to head 2. If you have printer with one or two twin-nozzle heads, message numbers
increase two numbers at a time.
Validate the library:
Ƒ Highlight the VALID button
Ƒ Press
.
Message title
Number of head which can print
message
Message sequence number
in library
List of messages
in library
General
message list
Number of
messages
To Next Page
Loading...
