Installation and configuration
A36951-C.doc
189/236
Select machine options
Printer preparation/Options/Machine options
This function allows you to specify whether specific options are to be made available
_ or
not
.
ʄ Printing msg in lib. each DTOP
For printing a new message from the library on each DTOP signal. When the final
message in the library is printed, the printer then selects message no. 1 for the next
following printing task.
ʄ Speed fault override
To override "print speed" faults. These faults will not be registered or indicated.
ʄ Cable printing option
To continuously increment counters on object signal regardless of jet status (if the jets are
stopped or in fault condition).
ʄ Julian post date (offset)
To add a number between 0 and 633 to the Julian calendar. The total value (current date
plus offset) must not exceed 999.
ʄ One DTOP per message
Prevents message from being printed more than once.
ʄ Drop flight compensation
To minimize any variation in position of the marking made on the substrate if there is any
variation in the speed of the conveyor. The speed must be 0.2 m/s or above.
Compensation is not applied at lower speeds.
To Next Page
Loading...
