Maintenance
A36951-C.doc
141/236
Ŷ Jet maintenance
Starting problems
A number of functions are available for restoring the jet(s) to good working order if the
jet(s) will not start correctly (no jet or deviated). Follow the instructions on the screen for
each of these functions.
Ensure that the head is positioned onto its maintenance holster and the cover is removed.
1. Stop the jet(s).
2. Close the recovery gutter screw in the print head.
3. Select and confirm: NOZZLE UNBLOCKING
Using the squirt bottle, apply cleaning solution to the
cannon until ink flows through the nozzle.
If the jet is in the gutter, move on to step 5. Otherwise, go
to step 6.
4. Select and confirm: INTRO. SOLUTION
Using the squire bottle, allow cleaning solution to run along
the cannon for around 20 seconds.
To Next Page
Loading...
