Servicing: 9040 Contrast
A36951-C.doc
127/236
Ŷ Prolonged shutdown
CAUTION Always disconnect the printer from the main AC supply after
draining and flushing if you are not going to re-introduce ink
immediately. This is to avoid having the stirrers rotating with no
fluids in the ink/solvent tanks.
Drain and rinse the printer before any work, which requires
disconnection from the main AC supply for more than two
hours.
Shutting down the printer for between 2 hours and 4 days
1. Stop the jet(s) and place the head(s) on it’s
the maintenance holster.
/
Jet
status/STOPPED
2. Open the head cover.
3. Spray cleaning solution into the recovery
gutter for a few seconds.
4. Shut down the printer.
5. Close the gutter (after the printer is shut down
completly).
6. Place the anti-clogging device under the
nozzle(s), if necessary (see the IRS – Ink
Running Specification/technical data sheet for
your ink type).
7. Close the head cover.
To Next Page
Loading...
