Servicing: 9040 Contrast
A36951-C.doc
129/236
Ŷ Start-up following a prolonged shutdown
Restarting the printer after a shutdown lasting between 2 hours and
4 days
1. Open the head cover.
2. Remove the anti-clogging device from under
the nozzle(s) (if present).
3. Clean the print head.
4. Open gutter.
5. Start the printer with the cover open. Start the
jet(s) if they don't start automatically.
6. Close the cover when the jets have started
and place the head on its production support
bracket.
Starting the printer after it has been out of service for four or more
days
1. Change the main ink filter cartridge if the
printer has been shut down for longer than 15
days.
Refer to the procedure for changing 9040
Contrast printer ink filter cartridges contained in
the Maintenance section of this manual.
2. Pour half a liter of new ink into the ink tank.
3. Start the printer normally and leave in
standard operation with jet(s) running for a
minimum of thirty minutes.
CAUTION Do not place additive in the additive tank until you have
checked that the ink viscosity reading is within the specification
for your ink.
To Next Page
Loading...
