Dover Markem Imaje 9040 - Start-up After Extended Shutdown (>4 Days)

Servicing: 9040 Contrast
A36951-C.doc
130/236
4. Check the viscosity.
Ƒ If the value is below "Reference visco. :"
Shut down the printer normally and empty the recovery tank.
Then pour half a liter of fresh ink into the ink tank.
Then restart the printer normally.
Ƒ If the value is above "Reference visco. :"
Pour a liter of additive into the additive tank.
Then restart the printer normally.
Allow the printer to run as the viscosity management system will correct itself
automatically.