Editing a message
A36951-C.doc
80/236
Ŷ Use a barcode
If you want to print a barcode, you first have to specify the parameter settings, then
compose the code and finally insert it into the message.
You can insert up to four barcodes into each message.
Set barcode parameters
Message editing/Parameters/Barcodes
Select the type of barcode from the list displayed.
The following types of codes are available:
Ƒ Industrial: interleaved 2 of 5, code 39, ITF14, ITF6.
Ƒ Distribution: EAN 13, EAN 8, UPCA, UPCE, EAN 128, code 128, HIBC/EAN.
Ƒ Two-dimensional: Datamatrix.
See "Barcode characteristics" section contained in this manual for further details on these
codes.
Confirm selection. The code parameter screen is displayed:
To Next Page
Loading...
