Editing a message
A36951-C.doc
81/236
The dialog box is specific to the type of code selected, and the user can only access
parameters settings that can be changed. Other parameters are shown in dotted
characters and cannot be modified.
ʄ Narrow bars
Enter a value from 1 to 4 units (default value is 1 for distribution codes). The Narrow bars
value must always be less than the Wide bars value.
ʄ Narrow spaces
Enter a value from 1 to 4 units (default value is 1 for distribution codes). The Narrow
spaces value must always be less than the Wide spaces value.
ʄ Wide bars
Enter a value from 2 to 9 units (default value is 2 for distribution codes).
ʄ Wide spaces
Enter a value from 2 to 9 units (default value is 2 for distribution codes).
ʄ Plain text
Specify whether the barcode is to be printed below the code (BELOW) or whether no text
is to be included (NONE)
ʄ Height
Select one of the height values available. This value is expressed in dots and must
correspond to the height of the fonts loaded.
ʄ Inverse print
Select whether to print in reverse video - yes
_ or no (except for Datamatrix).
ʄ Check digit
Choose whether check digit present- yes
_ or no .
If you choose yes, the printer adds the check digit to the end of the barcode automatically.
The check digit is not displayed and is only available for industrial codes.
ʄ Optimization
Check this box if you want to optimize the size of CODE 128 and EAN 128 barcodes.
To Next Page
Loading...
