Daily operation
A36951-C.doc
47/236
Markem-Imaje technicians can program the printer to include an "Active stand-by" mode.
In this mode, the printer performs a five-minute head cleaning cycle automatically once
every hour to ensure a problem-free start-up. The mode is active for 72 hours after a
prolonged shutdown and 8 hours after a short shutdown.
Stopping the printer
This procedure applies if the printer is to be stopped for less than 2 hours.
CAUTION
Do not interrupt the shut-down procedure.
1. Press to shut down the printer.
(
Production/Printer/Shut-down)
2. Press
ҏ to confirm.
The shutdown phase lasts approximately 2 minutes. The jet is stopped automatically.
The printer is shut down, but it is just the ink circuit which is taken out of service
and some of the interface functions remain available.
To Next Page
Loading...
