Servicing: 9040 Contrast
A36951-C.doc
135/236
5. Select and confirm the Production/Maintenance/Flushing function to start the
automatic drain cycle and monitor the progress.
The flushing solution will circulate inside all parts of the ink circuit and is then drained via
the ink tank. Draining stops and the printer shuts off automatically when the additive tank
is empty, the flushing cycles are now complete
6. Close the recovery gutter screw in the print head.
7. Clean the printhead
8. Place an anti-clogging device under the nozzles if
required.
9. Fit the drain plug back on the ink tank drain tube.
To Next Page
Loading...
