Maintenance
A36951-C.doc
151/236
ʄ Adjustment
1. Start the jets (JET START UP), once Jets are in a Ready mode,check motor the
speed.
2. Pull the ink circuit out to the end of the rails. Insert an Allen key or small screwdriver
into recess (3) of the pressure pump- depending on pump model.
3. Turn the tool half a turn either clockwise (decrease motor speed) or counterclockwise
(increase motor speed) and wait for the motor speed value to change on the printer
cabinet screen and stabilize. Gradually adjust until the motor speed is 2000 rpm (to
nearest 50 rpm).
NOTE You may have to make this adjustment after changing the main
ink filter cartridge.
Figure 1
1
Pressure pump
2
By-pass adjustment
3
Seal screw (Caution: Do not unscrew)
2
1
3
To Next Page
Loading...
