Maintenance
A36951-C.doc
158/236
Ŷ Change ink filter cartridge: - -
Tools required:
Ƒ Allen key (3 mm)
1. Shutdown the printer normally and disconnect from main AC supply.
2. Pull the ink circuit out to the end of the rails.
3. Drain the ink circuit. (see procedure)
4. Open main filter. Take out the cartridge.
CAUTION There may be ink inside the main filter housing.
5. Place the pulsation damper is back in position and fit the new filter cartridge. Fit a new
O-ring into the base of the filter housing. Ensure all drain circuits are closed and pour a
small quantity of ink into the tank.
6. Start the printer. Check for any leakage and ensure the pressure is correct. Perform
routine checks.
1
Drain screw
2
Main filter
3
Metal pulsation damper
4
Filter cartridge
5
O-ring
5
1
1
4
3
2
To Next Page
Loading...
