Installation and configuration
A36951-C.doc
193/236
Insert an RJ45 network cable in the Ethernet connector (the foolproofing tab prevents the
connector being inserted incorrectly).
Use a crossover RJ45 network cable to connect the printer directly to a PC or a straight
cable to connect it to a hub or switch.
ʄ Configuring the link
Printer Preparation/Initialization/Ethernet Link
Setting the IP address
The IP address is set automatically by default (from a DHCP server). Please contact an
Markem-Imaje technician if you need to set the IP address manually.
NOTE
If a DHCP server is not available, the IP address is set to
127.0.0.1 by default.
Port number
Select the connection port number, from 1024 to 9999.
The default port number is 2101.
To Next Page
Loading...
