Editing a message
A36951-C.doc
99/236
To create a new symbol in a front:
Ƒ Access the font (using the font name or number).
Ƒ Give a number to the new symbol.
Ƒ Draw the symbol.
Ƒ Save.
ʄ Save the symbol
Symbol editing/Symbol/Save
Use this command to save the symbol which you have just created or changed.
Symbol editing/Symbol/Save as
Use this command to save a modified version of an existing symbol without losing the
original.
These commands can only be accessed after using the New or Open commands.
ʄ Close the font
Symbol editing/Symbol/Close
Use this command to exit the font in which you have just created or changed a symbol.
The font contents are saved.
ʄ Download the font
Printer preparation/Initialization/Font(s) downloading
This function is for transferring a symbol font, which has just been created or changed.
THE FONT MUST BE DOWNLOADED BEFORE IT CAN BE USED IN MESSAGE
EDITING MODE.
To Next Page
Loading...
