Vigor2925 Series User’s Guide
459
stream with the peer side using the same protocol
(ZRTP+SRTP). Check this box to have secure call.
Cancel
Return to previous web page.
After finishing all the settings here, please click OK to save the configuration.
Note: If the incoming or outgoing calls do not match any entry on the phonebook, the
router will try to make the call "being protected". But, if the call ends up "unprotected"(e.g.
peer side does not support ZRTP+SRTP), the router will not play out a warning message.
D
D
i
i
g
g
i
i
t
t
M
M
a
a
p
p
For the convenience of user, this page allows users to edit prefix number for the SIP account
with adding number, stripping number or replacing number. It is used to help user having a
quick and easy way to dial out through VoIP interface.
Available settings are explained as follows:
Item Description
Enable
Check this box to invoke this setting.
Match Prefix
It is used to match with the number you dialed and may be
modified by the action (add, strip or replace) with the OP
Number.
Mode
None - No action.
Add - When you choose this mode, the OP number will be
added before the match prefix number for calling out
through the specific route.
Strip - When you choose this mode, the partial or whole
To Next Page
Loading...
Need help?
General
