Vigor3900 Series User’s Guide
470
4
4
.
.
1
1
7
7
.
.
1
1
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
To enable the Central Management AP feature, the first thing you have to do is enabling port
settings. Click AP Management>>General Setup to get the following page.
Available parameters are listed as follows:
Item Description
AP Management
Check Enable to enable the settings configured in this page.
HTTP Allow
Click Enable to active the HTTP setting.
HTTP Port
Type a port number for HTTP. The default value is 9080.
HTTPS Allow
Click Enable to activate the HTTPS setting.
HTTPS Port
Type a port number for HTTPS. The default value is 9443.
Username
Type a username which will be used by any Access Point
trying to connect to Vigor router.
Password
Type a password which will be used by any Access Point
tried to connect to Vigor router.
Polling Status
Click Enable to activate polling interval setting.
Polling Interval
Type the time value (unit is second). The range is from 60 ~
86400.
Apply
Click it to save the configuration.
To Next Page
Loading...
