Copyright 2008 Baker Hughes Company.
English–PACE5000/6000 Instruction Manual | i
Introduction
The PACE5000/6000 are pneumatic pressure controllers. The PACE5000 contains one pressure
control module. The PACE6000 can contain up to two independent pressure control modules.
The color touch-screen displays the measured pressure and the status of the instrument. The
touch-screen enables selections and settings to be changed. The instrument can be operated
remotely through communication interfaces.
Safety
The manufacturer has designed this equipment to be safe when operated using the procedures
detailed in this manual. Do not use this equipment for any other purpose than that stated, the
protection provided by the equipment may be impaired.
This publication contains operating and safety instructions that must be followed to make sure of
safe operation and to maintain the equipment in a safe condition. The safety instructions are
either warnings or cautions issued to protect the user and the equipment from injury or damage.
Use qualified technicians
*
and good engineering practice for all procedures in this publication.
Pressure
Do not apply pressures greater than the maximum working pressure to the equipment.
Toxic Materials
There are no known toxic materials used in construction of this equipment.
Maintenance
The equipment must be maintained using the procedures in this publication. Further
manufacturer’s procedures should be done by an authorized service agents or the
manufacturer’s service departments.
Druck.com
Technical Advice
For technical advice contact the manufacturer.
WARNING Do not apply pressure greater than the maximum safe working
pressure.
* A qualified technician must have the necessary technical knowledge, documentation, special test equipment
and tools to carry out the required work on this equipment.