Druck PACE5000 - Status; Vent Setup; Global Setup; Supervisor Setup

Copyright 2008 Baker Hughes Company.
48 | PACE5000/6000 Instruction Manual–English
Chapter 6. Reference
6.6 Status
The display shows the following:
a. Instrument status
• Module 1 (Module 2 if fitted)
• Control sensor
• +ve source sensor
• -ve source sensor
• Barometric sensor (Optional)
b. Software build - read only data
c. Hardware build - read only data
d. History - read only data
e. Communications
f. Current setup - read only data
g. Use log - read only data
h. Software options - read only data
i. Summary - read only data.
6.7 Vent Setup
Use the vent setup to prevent damage to rate-sensitive equipment connected to this controller.
The vent slew rate setting is independent of the controller slew rate settings.
6.8 Global Setup
6.8.1 Supervisor Setup
PIN protected menu. Refer to Section 6.9, “Supervisor Setup,” on page 49.
6.8.2 Calibration
PIN protected menu. Refer to Section 6.9, “Supervisor Setup,” on page 49.
6.8.3 Save/Recall user setup.
a. Save user setup.
b. Recall user setup.
6.8.4 Display
a. Resolution
b. Backlight
c. Audio volume
d. Status area.
e. Screen mode (PACE 6000 only).