Installing the Hardware
ā²
ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā
DS1103 Hardware Installation and Configuration March 2004
Iā ā ā ā ā ā ā ā ā ā ā ā ā
ā¼
42
ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā¼
7 Reconnect the PC, the expansion box and all connected devices to
the power supply.
Result The installation is complete.
Next steps ā If your system is installed in an expansion box, it must be
connected to your host PC via Ethernet or a bus interface. For
further information, refer to Connecting an Expansion Box to the
Host PC on page 51.
ā You can turn on the dSPACE system. Refer to How to Switch On a
dSPACE System on page 43.
To Next Page
Loading...
