dSPACE DS1103 Hardware Installation And Configuration

Setting Up an Ethernet Connection Between PC and Expansion Box ▲ ■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
■
DS1103 Hardware Installation and Configuration March 2004
I■■■■■■■■■■■■■ ▼
94
■■■■■■■■■■■■■■■▼
How to Change the IP Address of the Expansion Box
(Windows 2000/Window XP)
N
■ Before trying to change the IP address, be sure that you have
tested the peer-to-peer connection to your expansion box via the
ping command.
■ The IP address of the expansion box can be changed only if the old
IP address is known and the host can connect to the expansion
box. If the IP address of the expansion box is unknown, refer to IP
Address lost on page 242.
1 Contact your network administrator to obtain an unused IP
address that you can use for the expansion box.
2 To change the IP address, use the
setip utility located in
%DSPACE_ROOT%\exe . In a DOS window, enter the command:
setip <current IP address> <new IP address>
The new IP address will be valid after rebooting the expansion box.
E
The default IP address of the expansion box is 192.100.100.98.
The IP address assigned to the host PC for the peer-to-peer
connection is 192.100.100.1. With these settings the host PC can
connect to the expansion box as described in How to Set Up a
Peer-to-Peer Connection (Windows 2000/Windows XP) on
page 89. Assume that the IP address of the host PC was previously
set to 183.27.33.14. The IP address to be used for the expansion
box is 183.27.33.18. In a DOS box, enter the command:
setip 192.100.100.98 183.27.33.18
N
Write down the new IP address of the expansion box. You will
need it later to establish the connection.
3 Proceed with How to Restore the TCP/IP Configuration of the PC
(Windows 2000/Windows XP) on page 95.

dSPACE DS1103 Specifications

General

Brand	dSPACE
Model	DS1103
Category	Controller
Language	English