DURKOPP ADLER 827 Service Instructions

Maintenance
100 Service Instructions 827/827-M - 01.0 - 05/2019
20.3 Servicing the pneumatic system
20.3.1 Adjusting the operating pressure
Proper setting
Refer to the Technical data ( p. 117) chapter for the permissible
operating pressure. The operating pressure cannot deviate by more
than ± 0.5 bar.
Check the operating pressure on a daily basis.
Fig. 77: Adjusting the operating pressure
To adjust the operating pressure:
1. Pull the pressure controller (1) up.
2. Turn the pressure controller until the pressure gage (2) indicates
the proper setting:
• Increase pressure = turn clockwise
• Reduce pressure = turn counterclockwise
3. Push the pressure controller (1) down.
NOTICE
Property damage from incorrect adjustment!
Incorrect operating pressure can result in damage to the machine.
Ensure that the machine is only used when the operating pressure
is set correctly.
(1) - Pressure controller (2) - Pressure gage
①
②

DURKOPP ADLER 827 Specifications

General

Brand	DURKOPP ADLER
Model	827
Category	Sewing Machine
Language	English