EasyManuals Logo

DURKOPP ADLER 827 Service Instructions

DURKOPP ADLER 827
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
Thread trimmer
60 Service Instructions 827/827-M - 01.0 - 05/2019
To adjust the height of the thread-pulling knife:
1. Open the throat plate slide ( p. 18).
2. Loosen the screw (5).
3. Disassemble the thread-pulling knife (2).
4. Place as many washers between thread-pulling knife (2) and knife
carrier (4) as necessary to ensure that the upper edges of counter
blade (1) and thread-pulling knife (2) are at the same height.
5. Non-required washers on the top side between the thread-pulling
knife (2) and screw (5) should be kept.
6. Tighten the screw (5).
14.2 Adjusting the cutoff curve
Fig. 43: Adjusting the cutoff curve (1)
Proper setting
The control cam (3) makes direct contact with the set collar (1).
The distance between the widest extent (6) of the control cam (3) and
the roller (5) is 0.1 mm at most.
In resting position, the circle mark on the cutting edge of the thread-pulling
knife is exactly next to the tip of the counter blade.
To adjust the cutoff curve:
1. Tilt the machine head ( p. 14).
2. Open the throat plate slide ( p. 18).
3. Loosen the threaded pins (2).
4. Push the set collar (1) as far as it will go to the left.
5. Tighten the threaded pins (2).
(1) - Set collar
(2) - Threaded pins
(3) - Control cam
(4) - Threaded pins
(5) - Roller
(6) - Widest extent
(7) - Clamping screw
(8) - Lever
(9) - Solenoid
③④

Table of Contents

Other manuals for DURKOPP ADLER 827

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DURKOPP ADLER 827 and is the answer not in the manual?

DURKOPP ADLER 827 Specifications

General IconGeneral
BrandDURKOPP ADLER
Model827
CategorySewing Machine
LanguageEnglish

Related product manuals