Programming
Service Instructions 827/827-M - 01.0 - 05/2019 87
19 Programming
All software settings are performed using the OP1000 control panel.
The control panel is composed of a display and buttons.
Using the control panel you can:
• Use groups of buttons to select machine functions
• Read service and error messages.
Information
This chapter describes the machine-specific functions of the OP1000
control panel.
Refer to the Instructions for use DAC basic/classic for further
information on the control and the OP1000 control panel.
You will find the machine-specific parameters in the parameter list.
Fig. 72: Programming
(1) - Power LED
(2) - Thread button group
(3) - Function button
(4) - Programming button group
(5) - Seam program button group
(6) - LED for 2
nd
stitch length
(7) - Display
To Next Page
Loading...
