DURKOPP ADLER 827

Winder
58 Service Instructions 827/827-M - 01.0 - 05/2019
13.2 Adjusting the hook thread guide
Fig. 41: Adjusting the hook thread guide
The position of the hook thread guide determines how the hook thread is
wound onto the bobbin.
Proper setting
The hook thread is wound on evenly over the entire width of the bobbin.
To adjust the hook thread guide:
1. Loosen the screw (1).
2. Turn the hook thread guide (2):
• To the front: The hook thread will be wound on further to the front
• To the rear: The hook thread will be wound on further to the rear
(1) - Screw (2) - Hook thread guide
①②