Adjusting the handwheel scale
Service Instructions 827/827-M - 01.0 - 05/2019 25
4 Adjusting the handwheel scale
Proper setting
1. Lock the machine in place at position 2 ( p. 22).
The handwheel is at position 0°.
If a different degree number is next to the marking (2), then you will
have to reset the graduated scale.
Fig. 11: Adjusting the handwheel scale
To adjust the handwheel scale:
1. Lock the machine in place at position 2 ( p. 22).
2. Loosen the fastening screw for the handwheel through the screw
opening (1).
3. Turn the handwheel so that the marking (2) points to the degree
number 0°.
4. Tighten the fastening screw.
5. Turn the handwheel to 50° and tighten the 2
nd
fastening screw.
(1) - Screw opening (2) - Marking
To Next Page
Loading...
