Thread trimmer
64 Service Instructions 827/827-M - 01.0 - 05/2019
8. Turn the control cam (3) such that the roller (1) runs up at the contour
of control cam (3) and the widest extent of the control cam is at hand-
wheel position 60° at the highest point.
9. Tighten the threaded pins (6).
10. Check adjustment:
• Insert the thread into thread-pulling knife (4) and slowly turn the
handwheel.
• Check the handwheel position at which the thread is cut.
11. If necessary, repeat adjustment steps 1 – 7 until the cut takes place
at 60°.
To Next Page
Loading...
