Maintenance Manual (960-943) 2-24
Troubleshooting Procedures
Procedure 4: Connector Check and Replacement Check
Scan your finger shown below:
Straight your finger and touch the center of the fingerprint sensor lightly and
lift your finger.
Figure 2-5 Scan the finger
2.15.1 Procedure 1 Setting Windows sign-in password
To use the fingerprint functions, registration of your fingers on “Windows
Hello” after setting the Windows sign-in password and PIN.
2.15.2 Procedure 2 Registration of PIN and fingerprint
1. Sign-in to a user account where you want to register the fingerprint
information.
2. Click [Start] button.
3. Click [Settings].
4. Click [Accounts] -> [Sign-in options].
5. Click [Add] of [Windows Hello PIN].
The message to confirm the account’s password will appear.
6. Input the Windows password to [Password] and click [OK] button.
The display to set PIN will appear.
7. Input numbers you want to set to [New PIN].
Set four or more numbers as the PIN.
8. Input the PIN number you set to [PIN confirmation] and click [OK].
9. Then click [Setup] of [Windows Hello Fingerprint] in [Sign-in options].
[Windows Hello Setup] screen will appear.
10. Click [Start].
The screen with a message for checking the user will appear.
11. Input PIN number to [PIN].
The screen requesting to swipe on the fingerprint sensor will appear.
12. Touch your finger on the fingerprint sensor and lift it.
Repeat it until setup is complete. (The message to show the completion
will appear.)
To Next Page
Loading...
Need help?
General
