Maintenance Manual (960-943) 3-3
Tests and Diagnostics
When the message above is displayed, press Y. The ME FW
will be updated and the computer will restart. Then repeat
from Step 2.
Procedure 2: Check of hardware information
The program checks and displays the hardware information
such as HDD and SSD of the computer.
When a system board is exchanged and DMI information is
not written in, the DMI information can be registered with this
program.
Refer to 3.3 Entry of the DMI information for details.
Procedure 3: Check and update of BIOS information
The BIOS version is checked and if it is not the latest one,
the message to confirm if update is needed or not. The
current version is displayed at upper part of the display.
Does it update BIOS (Vx.xx->Vx.xx)? (Y or N),
or press [Enter] (Selection=Y)?
When the message above appears, pressing ENTER will
start BIOS update.
Then, since the computer reboots automatically, repeat from
Step 2.
If BIOS update is not needed, press N.
Procedure 4: Check and update of EC/KBC information
The EC/KBC version is checked and if it is not the latest one,
the message to confirm if update is needed or not. The
current version is displayed at upper part of the display.
Does it update EC/KBC (Vx.xx->Vx.xx)? (Y or
N), or press [Enter] (Selection=Y)?
When the message above appears, pressing ENTER will
start EC/KBC update.
Then, since the computer reboots automatically, repeat from
Step 2.
If BIOS update is not needed, press N.
To Next Page
Loading...
Need help?
General
